infinite cycle with old settings

[gristlekinginc]

Bought the prebuilt unit and successfully set up the HASPone plate last night. Added time & temp and it worked. Modified the page names to reflect what I'd do with each page. I did at least one other thing, but I can't figure out what it was, however...now the plate is infinitely cycling through from WiFi Connecting (which it seems to do), to a few milliseconds showing the setup, to the standard 4 button/3 page setup that is first blank, then shows Page 1/2/3, cycles briefly to the custom names, then pack to Page 1/2/3, then starts over. The whole cycle takes about 8 seconds.

I've tried removing the HASPone blueprints multiple times, have reset the plate multiple times, have restarted HA multiple times as well as deleted any entities or anything that has HASPone on it.

The reset works (meaning I can wipe it clean, go through the connect to local WiFi steps, and add in the HASPone Core Blueprint to HA. When I RUN the HASPone Core blueprint the cycle starts up.

When I go to reset it I do see the following:
Last reset: Fatal exception:4 flag:3 (Software Watchdog) epc1:0x4022f2c8 epc2:0x00000000 epc3:0x00000000 excvaddr:0x00000000 depc:0x0000000

I didn't find anything on a Google that indicated what I should do next. What should my next steps be?

[gristlekinginc]

Finally found a bunch of files in automations.yaml, removed those, and that seemed to fix it.