jump container for single output?

[Diax170]

So there were recently breaking changes for the jump feature. And I noticed when invoking jump container it jumps through focused containers on both outputs. Now, is this even intended? Is there a way to make it jump on the current output only?

[dawsers]

Yes, jump went through a lot of changes to provide more features and simplify code in 1.12.9 (see release notes). To be consistent, every jump mode allows you to jump on every enabled output (including jump container, which will select the active container for each output). Now there is also an all argument for every jump mode that leverages the new workspaces overview to show filtered containers for every workspace on each output.

I recommend checking the default config,.in to see all the possibilities and new default key bindings.

mode "jump" {
    bindsym  slash jump tiling; mode default
    bindsym  Shift+slash jump tiling all; mode default
    bindsym  c jump container; mode default
    bindsym  w jump workspaces; mode default
    bindsym  f jump floating; mode default
    bindsym  Shift+f jump floating all; mode default
    bindsym  a jump all; mode default
    bindsym  Shift+a jump all all; mode default
    bindsym  s scratchpad jump; mode default
    bindsym  t jump trailmark; mode default
    bindsym  Shift+t jump trailmark all; mode default
    bindsym  v jump; mode default
    bindsym  r jump criteria [app_id="firefox"]; mode default

    # Return to default mode
    bindsym Escape mode "default"
}
bindsym  $mod+slash mode "jump"

scroll goes through many changes. It is useful to compare one's config with config.in and man 5 scroll every now and then to see what new features and changes are happening. The changes are usually documented there and in the release notes.