diff --git a/client.cfg b/client.cfg
index 8f2eadf..dfbf459 100644
--- a/client.cfg
+++ b/client.cfg
@@ -123,6 +123,7 @@ gcode:
   {% set velocity = printer.configfile.settings.pause_resume.recover_velocity %}
   {% set sp_move = client.speed_move | default(velocity) %}
   {% set runout_resume = True if client.runout_sensor | default("") == ""   # no runout
+                    else True if printer[client.runout_sensor] == null      # no filament sensor
                     else True if not printer[client.runout_sensor].enabled  # sensor is disabled
                     else printer[client.runout_sensor].filament_detected %} # sensor status
   {% set can_extrude = True if printer.toolhead.extruder == ''           # no extruder defined in config