Did you know that you can use the ExtremeXOS Notepad ++ XSF style template to help writing .xsf scripts?
| Script Name | Description |
|---|---|
| 6in4tunnel | Configures an IPv6 6-in-4 tunnel between two IPv6 regions bridging across an IPV4 region on an ExtremeXOS switch. |
| autofsbackup | Runs automated back up on all scripts, including configuration, policy and scripts. |
| cfmmepport | If there is a CFM event, this Universal Port script dynamically disables the port. |
| chib | Save energy by placeing specified blades into a standby state. |
| disablefaultedpoe | This script will iterate through all ports on an ExtremeXOS(TM) switch and check if the port is in a PoE fault state. |
| disableonlinkdown | This will set up a UPM profile to automatically disable a port if the link goes down. |
| edpavp | This script will auto-configure an edge switch based on the ports seen on the uplink port using EDP. |
| enablefeaturescheck | This script identifies the features enabled on a switch. |
| fwvcvalidate | When a switch boots, this script matches the configured-firmware-version with the correct-firmware setting. |
| IP SLA | This script provides an example of IP SLA by using UPM scripting with UPM timers. |
| ipv6uniconfig | This script provides an example of IPv6 unicast routing in ExtremeXOS. |
| latencyfortdmcalc | This tool calculates the estimate of PSN bandwidth and the end-to-end latency incurred in encapsulating given TDM payload. |
| legacysnmpv1v2 | This script provides an example of SNMP V1/V2 configuration for an ExtremeXOS(TM) switch. |
| poeupmdisable | This script disables inline-power on faulted ports, and enables inline-power when the port goes down. |
| poeincremental | This script allows powering up PDs Incrementally. |
| pwrdwndaily | This profile turns power off at a specific time of day to a list of Power-over-Ethernet enabled ports. |
| qosconfig | Allows for advanced QoS settings to be easily provisioned on many ports. |
| radiusmgmtconfig | This script provides an example for configuring an ExtremeXOS(TM) switch with RADIUS management information. |
| radiusnetloginconfig | This script provides an example for configuring an ExtremeXOS(TM) switch for RADIUS netlogin. |
| sntpconfig | This script provides an example for Simple Network Time Protocol (SNTP) configuration for an ExtremeXOS(TM) switch. |
| tbmr | Based on time, restricts network usage to preconfigured MAC addresses. |